Camco 02102/02103 1000W 120V Screw-In Water Heater Element - High Watt Density

Great product reduced my 1,400-watt heating element to this new 1,000-watt.Works perfectly.Also, the original heating element was causing a lot of heat.* make sure when filling the RV tank to use 3 filters set up coming into the RV to reduce contamination of water hard lime.* I use a 1-micron 1st stage then 2nd stage 0.5-micron 3rd filter 0.2 micronThis will keep all your plumbing lines & fixtures sinks, toilet, plus water heater clean of debrisOnly use Pure Sine Wave Inverter if you're on solar.1 hour 10 minutes to heat 10 gallons of hot water from my Atwood GC10A-3E water heater.

It's hard to find a lower wattage like this one. It still does a good job, but it gives us 500 watts we can use somewhere else. Sometimes with the original 1500 watt unit, having the refrigerator on park power then turning on the microwave or air conditioner will sometimes cause the park circuit breaker to flip off. Using this unit solved all that.

quality material. good price, easy to install. It worked. Will recommend to others.

Not for use in a water distiller. I used it in the boiler tank of my dol-fyn water distiller, it lasted only 4 days. I learned that when the clean distilled water reservoir gets full, and the float tells the water distiller to shut off, it continues to boil the tank almost completely dry. This heater is smaller than the factory original and when the water level gets too low, one side of the heater gets exposed to the air. It immediately overheats and burns out. Now I know why the factory original part costs $60. This little heater worked great, and if it was installed in a small on-demand water heater, it would work perfectly. Just don't try to use it in a distiller.

very small and suits "in pipe" instalation.

Great price on product, but element burned out in less than two days of use. So went to local hardware store and bought a little better quality item.

standard screw in, worked on 30 gal 120 volt waterheater

Used for a solar powered element for my hot water heater. Replaced the lower element and electrified it with 2 @ 300 watt solar panels. Amazing results.

Medida estándar para Boyler eléctrico, de calidad, instalación fácil, material en acero inoxidable (duradero)

Easy to install

Installation is easy as long as you have the proper socket or configuration of wrenches.

Excelente producto, calienta muy bien en 25 min calienta una cubeta de 20 LTs para bañarte

We have replaced this many times for our stainless steel hot water tank. It’s on our salmon fish troller and workswell. Our tank is large and this element works well for us. We bought two, always keeping a spare on hand.